Painting Methods used by Industrial Painting Contractors
Industrial painting contractors in Ohio has different methods which they use when they coat the surface using the paint. Contrary to home decorators, there are different ways of adding a layer of the paint on a building using a roller or a brush. The surface in industrial painting will also require better preparation.
Preparation is important, and it is the key if the paint will last long. When the surface that should be painted was not painted before, then the entire process will be easier. However, it still requires the skills and touch of an expert. When there is already an old coat, then it has to be removed before applying the second coat.
The surface has to be prepared by the use of ultra high-pressure water jet. It has both the blasting and washing effects. It removes dust and grit and all other loose particles. Water jetting will leave the surface looking clean compared to preparation methods used. It may also be used in any weather, and it does not cause the adverse environmental problems.
Abrasive preparation is also done by the industrial painting contractor, it can be wet or dry, or a combination of the two. This is a method used to remove chemicals, dust, grit, and rust so that he place can become new for the application of the paint. If sufficient care had been used and the attention had been taken, the painting process will be easier, and there is a greater chance of success.
When it comes to industrial painting, applying the paint using a roller or a brush, is not the only option. Powder coating is also the process where particles of dry paint are electrostatically charged before it is applied and it is positioned on a grounded surface. These particles will be held on the surface using electrostatic attraction. The heat is applied afterward, and it allows powder coating to flow with it, and it may be cured in one place.
Before using powder coating, it is important that the surface may be prepared so that it can be electrically conductive. This was used on the metal surface before. However, with the recent advancement in technology, it means that other surface like wood and plastic can be treated by the use of this method.
Coil coating is also known as roll coating. It is a high-speed method used in applying the paint coating on a metal area. It is a continuous process at the same time faster. It is a most effective method that you can find around if you want to get the paint to a metal surface and it is kind to the environment.
Spray coating has become common when it comes to applying the paints to the surface like extensively used by the industrial painting contractor. It is a method that can deliver the sealant the resin effectively under pressure. The inherent messiness which is found with another painting method like overspray, it will be minimized greatly when an electrostatic charge is sprayed.